How To Clean Your Usb Charging Port Samsung S8

How To Solder/Supervene upon A Samsung Galaxy or iPhone Charging Port

By May | January 5th, 2022 | | 4

Charging port is ane of the nigh vulnerable parts in a smartphone. The charging port is easily to loosen later on being plugged in and out or getting stuck by dusts or rust. A broken charging port will certainly influence the charging speed as well every bit the charging outcome. To supersede a charging port merely costs less, but requires more complicated skills than replace a charging port with PCB board. Here nosotros walk yous through how to replace a Samsung Galaxy phone or an iPhone charging port.

Tools Needed:

Rut Gun
Soldering Tin
Soldering Paste
Toothpicks
Tweezers

Samsung Galaxy S2/3/iv/5/6, Note two/iii/4/5, Notation Edge/S6 Edge/S6 Edge Plus USB Charging Port Soldering Tutorial Guide

(Take Galaxy S3 as an case.)

Footstep one: Become some soldering paste with the help of a toothpick, gently apply information technology around the welding areas of a charging port.

Step two: Heat uniformly on the welding areas.

By and large, the charger port is built into a PCB board (aka a girl board), which should exist heated at about 280 ~ 300 centi-degree in the starting time minute, 320 centi-caste will be fine afterwards.

Every bit for the charging port being built into a flex ribbon (i.e. Galaxy Tab S x.5 charging port with flex), the heating temperature should be turned down to 280 centi-caste from outset to end so equally to protect the frail flex cable ribbon from burnt.

galaxy tab s 10.5 charging port.jpg

Step 3: Gently remove the charger port with the help of a tweezers.

Step iv: Employ some soldering tin around the welding areas of the daughter board evenly, then apply the soldering paste in the same path.

Footstep 5: Gently put the replacement USB charger port in the soldering areas, slightly adjust the charging port to the right place, fix it with a tweezers while heat information technology at the same time.

iPhone 4/4S/5/5C/5S/vi/half dozen Plus/6S/6S Plus USB Charging Port Soldering Tutorial Guide

(Take iPhone 5 equally an instance.)

Step 1: Heat upward effectually the charging port welding areas uniformly.

Step two: Gently remove the charging port by a tweezers.

Step 3: Apply some soldering tin around the welding areas of the daughter board evenly, then utilise the soldering paste in the same path.

Footstep 4: Gently put the replacement USB charger port in the soldering areas, slightly adjust the charging port to the right place, fix it with a tweezers while estrus information technology at the same time.